Vanquish Products 20mm Aluminum Clamping Servo Horn (25T-ProTek/Savox/Futaba)

Bought this to replace the stock servo horn on my Axial 10.3 Gladiator JT. Fits great and clears pan hard bar.

I've got a few of these servo horns made by Vanquish. Overall I like the design of these over any of the other brands I have used over the years. They are sculpted where they are plenty strong, but still allow for maximum clearance in tight places. The double set screws help to keep them clamped on. I haven't had an issue with one yet! Highly recommended!

Very thin servo horn yet still quite strong.

Perfect fit for the VS4-10.

Its a high quality servo horn, love that it clamps as well as standard mount.

Clamping screws were missing from the packet, so that’s another expensive, thanks Vanquish

BEEFY!! I’m using this on my VS4 build. Works like it should.

Great servo horn.After tightening clamping screws I dont even see the need for the center screw.Just great product.Only I wish it would come in black but that is just nitpicking.

Too thick for SCX10 II. It either hits the panhard bar mount or the frame itself depending on if shims are used.