Team Associated Off Road Ride Height Gauge

gets the job done. Mine is 3mm off. make sure to measure it with calipers before relying on it for accuracy.

Great product, works perfect. easy to put together. has picture instructions.

Holy Cow, this thing took longer to put together than my RC8T kit....LOL

Stickers are a P.I.T.A. to get off the plastic pieces. The screws are standard size, not metric. Use soap on the threads to screw them through the plastic pieces or you will have difficulties. But a pretty handy setup tool in general.

I just ordered one of these. After using my buddy's once I was sold. I had been using the Losi gauge and I must say you get what you pay for...total waste of 10 bucks. If anyone does not like this gauge especially over the Losi one, they must have been using it incorrectly. It took me using it once, after using the Losi for months to see that it was far superior to the Losi. The best one I have used besides the no brainer stepped ones.

If I had to buy another ride height gauge right now it would be the Losi one, this was a pain to build, the numbers are hard to read, and the base is narrow, it is hard sometimes to tell if it is sitting flat on the setup board. Also, the very end, the part meant to touch the bottom of the chassis can wobble up and down a good 2 mm on mine, that means the setup could be 2mm off right out of the gate, I don't much care for this thing at all.

I hear ya, and the screws, i couldnt find any driver to fit them, 1/16 was to small 5/64 was to big, it was like they were some weird size like 23/32, was very frustrating putting together, get the losi one, way cheaper and does just as good a job.