Team Associated 15.5mm Aluminum FT Clamping Servo Horn (25T-Futaba/Savox/ProTek)

Works great on my B6.2 with a Savox 1258 and ProTek 160T servos.

Too short for a B74.1, which needs a 20mm version (ASC1368) to clear the front driveshaft.

I run this on my Sc6.1 and with proper servo mount spacing it clears the top plate perfectly.

I use this on my B6.1D. It fits and functions perfect. B6.1/B6.1D comes with a revised top plate (ASC91766) that has a notch to avoid interfering the servo horn.

*** Those who claim this servo horn does not fit their B6.1 are probably using the B6 top plate, which share the same part number.

I installed this on a ProTek servo on my AE RC10B7D. I broke the plastic one in a practice session and knew it was inevitable. I had this on order anyway - installation was a breeze, fit was flawless, no binding or hitting on anything and the servo arm offset was spot on for the install on my B7D. It not only screws on, clamps as well... Super happy and this is solid!

As a servo horn it works but does not work for my vehicle (b74.1d which it says it does and does not) you will need 18.5 or 20mm version. Out money now ugg

Giving this one star because the description says its compatible with a b6.1 and it's not. The horn is too long and hits the buggy's top plate. I'd suggest changing the description. I purchased the Exotek top horn for the same buggy and servo (25 spline) and it's a direct fit. It's such a perfect fit that I don't need to use trims to get the car to track straight

So, this servo horn doesn't fit in the b6.1 as described. Not sure about the other vehicles.

After much trial and error I found that using a servo weight keeps the servo flat, I was determined to get this to work with no trimming, I was not successful, but I only had to make a few swipes with a knife while servo was still installed. ( I also researched and found out my servo is slightly larger, not the 20mm standard, if mine was 20mm it would have fit perfect, not associated’s fault). You will see with nothing under servo, front will be higher than back, putting the whole servo on an angle, it mattered more that I thought it would. **just my experience**