Tattu 2S 75C LiPo Battery (7.4V/450mAh) w/JST

Battery Overview:

Tattu LiPo Batteries have been developed specially for the UAV and UAS market. Their slogan is "less is more" - "more" for more flight time, more enjoyment, and more satisfaction; "less" refers to the light weight and simple design. Tattu always develops their products according to these ideals, giving you a high quality battery. Tattu batteries are matched using an automatic computer matching process that ensures the battery stability and quality.

Features:

• Stable automatic stacking technology.
• The most strict single cell capacity, voltage, resistance, discharge curve matching process.
• Superior Japan and Korea Lithium Polymer raw materials.
• Recommended for high performance 3D and FPV racing drone applications.

IMPORTANT LITHIUM POLYMER SAFETY INFORMATION

• DO NOT leave a battery in your model when charging
• DO NOT leave lithium batteries unattended when charging
• ALWAYS balance charge lithium battery
• ALWAYS use a LiPo Safe charging bag/box
• YOU MUST use a Li-Poly specific charger to charge lithium batteries (NiMH or NiCD only chargers WILL NOT WORK!)
• YOU MUST not over discharge lithium battery packs
• READ & UNDERSTAND the instructions carefully before operating this battery

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in overheated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for the first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at temperatures above 35°C or in a closed car. The high-temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging, or racing, do not charge it until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.