SSD RC Scale Locking Hubs (Red) (2)

These look amazing in person. They a very nice scale look to any rig. When posting pictures online on my rig with these equipped, people often have to do a double take. You will need the installation tool (SSD00008) to install these.

Don’t know how I see these on so many rigs... When I first ordered my set of 4 I was instantly unhappy with 1 of them because it was cross threading onto my axle. Within one week of running them the silver hub part falls off the actual nut inside. It has now happened on all 4 within two weeks, two runs and removed them once. For $30 a set of 4 and $6 for a damn tool this was a waste of money.

The picture does not do these hub locks justice, as they are nice and smoothly machined.

Does not work for the Axial Capra axles. These are too shallow for some nuts.

Nice added little touches that make your scale truck or buggy look like they're supposed to look in the full size.

Great look but need 243 loctite to avoid loosening

Amazing scale look for my Axial SXC1o iii. Easy instal with the speciality hub tool.

They look awesome on my scale truck. I recommend them.

Not real happy with this item. I wasn’t sure if I needed to remove stock trx4 wheel nut to install these, so I put one on with the stock but in place, it went on but looked kinda funny sticking out a little too far. Then I removed the wheel nut on the other side and screwed the locking hub on, it would only tighten so much. I tested the wheel tightness and the wheel wasn’t secure to the hub, so, like a dummy, i torqued it down and the stud was too long and it popped the nut out of the hub. Anyway, I ended up pressing the stock nut into the hub with vice grips, very tight fit but it worked. Will not just screw on a stock trx4, be prepared to be innovative Not sure how to add a picture or I would