SSD RC Rock/Baja Rey Scale Steel Rear Driveshaft

ok I had to purchase a new driveshaft for my baja rey because stock one got stuck and I did not have a loctite remover and had to break it apart such a noob. So I tested SSD as it was cheaper than the stock plastic, is thinner, probably heavier.

I tested it with 3200kv, 3s at 55%, worked well for the first run. I give it 4 stars because the screws do not fit the baja rey outdrives so you have to use stock ones (hopefully you did not lose or destroy them like me) or purchase a set LOS236003. I tried using shaft screws from different cars but all of them were thicker (MST, Axial, Losi, etc).

Update: I raced an entire weekend on a buggy track with ramps and very soft and unpredictable terrain and the ssd driveshaft did its job. I will change my rating to 5 stars but keep in mind that you need to purchase a set LOS236003 if you lost one or two of your shaft screws.

Less than one battery pack thru it and the pressed in pin at the U-joint came out rendering this part useless.

Looked good.did not have note about pin but figured out original pins fit.shaft wore out at pin joint.you would think it should last longer than 4 months!!

After buying this product was a surprise.
I cannot screw this nut (M4 set screw) into Pinion Gear.
The diameter of the M4 set screw is much larger than the hole diameter of Pinion Gear.
I cannot drill Pinion Gear into a larger diameter as I do not have such a strong, powerful drill bit for drilling Pinion Gear hardened steel.
It is also impossible to use a M4 set screw from a stock model plastic driveshaft as it dangles due to the fact that the holes are much larger than it.