RPM Front Bearing Carrier Set for Traxxas Slash/Bandit/Rustler/Stampede (Black) (2)

Ok here is the truth: RPM Front Bearing Carriers are the perfect combination of strength and durability, with just a touch of flexibility to save you when all other parts would have exploded like a parked smart car vs. a speeding 80,000lbs. semi truck. Yes they can break, but in a hammer like way: well used or a completely random fluke. I've never had any issues and they fit better then Mechanics Gloves.

Take it from someone who bashes his over-weight, over-powered slash almost daily.

R. Rugged
P. Performance
M. Masterpiece

work great. I have bought a number of rpm parts and have been very satisfied.. They are lighter and definitely stronger than stock.. I went through 3 stock traxxas front bearing carriers , two castor blocks and 2 rear bearing carriers in one track session.. Yes my children are not very good at driving the cars yet.. I digress.. Im not saying it wont happen. BUT... I have yet to break a single RPM piece on any of my trucks , including the trucks my kids use.. I have had no problem with interference or fit whatsoever.. I say great product and much cheaper than aluminium......... I do wonder if it would cost traxxas that much more to make there bearing carriers . bulkheads and castor blocks out of something better.. seems to be there weak point. I say go buy an aluminium bulkhead and RPM castor blocks and RPM front and rear bearing carriers right when you buy your truck... might as well. if your just a little rough with the truck they wont last long..

Awesome part. Super tough. Don't waste your money on traxxas part they just break again and again.

Kinda bummed they needed some internal clearance work done to get the bearings to fit properly and still be able to get the pin through the axle

These doesn't work with stock teflon washer and bearings. The inner wall is thick therefore wheel doesn't rotate freely.

Won't recommend.

They Suck! Don't waste your money. The center is too thick and when you install & tighten your wheels, they don't want to rotate. I also had to trim off excess on the carriers and my lower control arm due to interference fit. Traxxas replacement are only 1/3 the cash.