RPM Associated Rival MT10 Front A-Arm Set

A must if you bash hard. Almost unbreakable. Rpm plastic bends before it breaks. Cheap insurance

The RPM arms are one of the only upgrades the tough little Rival MT10 needs.

Regarding the other reviews, you can easily take a Dremel and just file out a teeny bit of material in the slot where the shock attaches. Otherwise, it's going to be a very tight squeeze attaching the bottom of the shock to the A-arm.

It's not a big deal. I'm sure RPM will address it in the future.

I had to Use a file to put the shock on and I called and reported the issues- and they were interested in the problem and concerned about getting it fixed- and they will investigate it and hopefully the problem will be fixed. I don’t know how long it will take but you better have a burr file handy- I will continue ordering from a main hobbies This is a great company.(fun fact ):The part is softer- not brittle-so it should not splinter or break as easily as the original parts so I’m giving it five stars -I’m going to order a full set front and rear next time

Good arms for the price. I broke the stock ones after like 4 months I got these and took it skate park bashing they held up really well. Although the pins keep popping out ever since I put these arms on.

These RPM seem to be made out of much tougher plastic then the factory ones, I have no doubt these ones are stronger and will last longer. Well worth the upgrade!

I did not install for two reasons. 1. The slot for bottom of the shock is not wide enough for the shock to fit. 2. They do not accommodate installation of the guard that protects the bottom of the shock.

I could dremel out the slot and make it fit but luckily I purchased Team Associated parts as well. No problem fitting the TA part and installing the shock protector.

I didn't receive. Don't want to have to buy agian