Racers Edge Finger Drill Bit Set (No. 54-59)

Complete junk! Junk drill bits! The small knurled handles all have an over size hole for the bit. The drill bit is then crimped into the handle. Looks like somebody took a pair of pliers and tried to squish the end. The bits just fell out of 3 of the 6. Also #57, #58, #59 were all the same size bits. As if the hobbiest is too stupid to measure with a mic. Those three measure .042 which would be a #58. So I received 3 #58 bits of the worst quality I've ever seen falling out of the handles. And #56, #55, #54 just junk bits (at least the correct size) crimped into a little junk handle and loose. Racers Edge should be embarrassed to sell a product like this. I'll be sure to never buy another product from them again.

I just bought a set from Hobbytown. The handles are exactly as described by Jason in the review above. If the bits do spin I will use some press locktight. Racers Edge should have used it before they crimped them though. I just measured all the bits with calipers and I guess I got lucky because they were the proper sizes. If you drill pistons a lot, get something better. If you only need them once in a while, these will be fine. Should only cost $8 in my opinion.