ProTek RC 1S 100C Hard Case LiPo Battery Pack (4mm) (3.7V/7400mAh) Supreme Power w/4mm Connectors

Price: $77.99
Discontinued Online
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.

This ProTek R/C "Supreme Power" 100C 1S LiPo Battery Pack is ROAR/EFRA/IFMAR approved and features 2C charge rates, 4mm bullet connectors and an ultra-high 7400mAh capacity.

This pack is awesome for 1/12 and 1/10 1S pan car applications and is built using a hard plastic case that is required for use at sanctioned tracks and events. A set of 4mm bullet connectors are included. 

Hi-Voltage Capable
This specially formulated battery features LiHV technology which allows the cells to safely reach a higher overall voltage (4.35V per cell vs standard 4.20V per cell). Achieving the higher voltage does require a LiHV capable charger, but the power gains are significant to the overall punch and power for the model. This battery can also charge and function perfectly at typical 1S voltages (4.2V), but please note: cell voltages exceeding 4.20V per cell is prohibited from sanctioned racing rules, such as ROAR, IFMAR, etc. 

Features: 

  • High 7400mAh Capacity
  • 100C Discharge Rate
  • 2C Charge Rates
  • Hi-Voltage LiHV Capable
  • Durable 4mm Bullets
  • ROAR, IFMAR, EFRA and BRCA Approved

Battery Model Supreme Power 100C
ROAR Approved Yes
Type Lithium Polymer
Capacity 7400mAh
Voltage 3.7V nominal
Connector Type
4mm Bullet
Balance Connector
Not Included
Number of Cells 1 Cell
Configuration 1S2P
Dimensions (WxLxH) 46.5x92.8x18.9mm
Maximum Charge Rate 2C (14.8A)
Continuous Discharge 100C (440A)
Watt Hour
27.4Wh
Weight 160g

 


LITHIUM POLYMER SAFETY INFORMATION

IMPORTANT:
1) DO NOT leave the battery in your model when charging
2) DO NOT leave unattended when charging
3) ALWAYS balance charge the battery
4) ALWAYS use a LiPo charging bag
5) YOU MUST use a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)
6) YOU MUST not over discharge the Li-Poly battery pack
7) READ & UNDERSTAND the instructions carefully before operating this battery

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage.

Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.

This product was added to our catalog on January 28, 2016