MST CMX/CFX CMS set

Installed this on my mst j4. I had to reuse the two spacers that have the four holes, two holes each piece, for the original screws that were mounted on the factory servo mount. I found that without them on the servo mount, would allow the screws to move and not tighten inline with the new mount. The spacers are located between the servo and the mount. Also had to spend allot of time adjusting the servo horn and linkage. I reused the original m3 x 10 screws as they would then not prevent the servo and mount from moving forward by the chasis and body mounts. Without the spacers,the old screws were too long. I did not end up using the new mount m3 x 8 screws.