Incision AR60 Spool/Locker

Good locker for what it is, feels very sturdy. The only problem is the fitment. When I got mine, it didn't mate up properly to the bevel gear for the differential (the axial 38t gear) and I had to file the pins down on the gear to get it to fit. Also the axles did not fit in properly either and the spool required modification. Overall very unimpressed. I had hoped for better quality but Incision has not been very precise with this part. Rather dissapointed.

Fitment is terrible! Cannot get it to fit correctly. the gear mesh is terrible.. Wouldn't recommended. I was expecting better from vanquish.

Was expecting a better fit than the stock locker. Axle slop is the same if not worse that it was with the stock locker when paired with Vanquish axle shafts. Finish of the part is excellent, but not a good fit. Also does not pair well with SSD axle housings. This locker pushed the ring gear slightly out of original position which required me to grind out the SSD diff cover for clearance.

ok locker. The tolerance isn't that tight. axle tangs push in and out no problem. better than stock at any rate!

Had mine for over 3 years now in my 12lb Custom Trophy Truck on 3s. Same issue as everyone else with the fitting the axial diff gear to it. I think it was an issue with the concentricity of the threaded holes with the spool. Other than that, its still running fine for me but these parts seem to be inconsistant. Probably buying another one for my second custom trophy truck build.

Little bit hard to install, but with some effort i got it in.
Great product, 100% recommend

I had no problems with this part. I saw others did for some reason. I did not. I popped on the bearings, it popped in, so far so good.