Hot Racing Arrma 1/8 Aluminum Upper Chassis Brace Rod Ends (2)

Excellent addition! Fits very nicely. 4 rubber o rings are for each side of the pivot balls to hold them in place not the rod ends like the guy said in the 1 start review. If you don't do what that guy did, it's perfect!

Fit my Arrma Felony perfect. Im about 75% aluminum.

pretty sure you have to get the hot racing rear brace mount with these as both of mine did not fit

Would not buy again. Nylon crush washer would make a lot more sense if they didn’t require the 4 O-rings included to get correct length. So there’s no contact between rod and rod end, just the threaded rod holding the 2 together. Factory ends sit flush against ends of rod. Also pivots are too wide, had to pound them in with nylon hammer, so a pain to align thru screws.