Horizon EC2 1/24 2.4Ghz ESC/Receiver

got my ESC jittering, and rolling backwards + left turn. Not reacting on any trim.
Replace a servo, thinking it's dead.
Now, after replacing an ESC and seeing same issue, before ordering the transmitter, I just replaced a batteries here.
Now I have a spare ESC and spare servo.

So for some reasons, instead of just turning off the Horizon's transmitter sends full backwards throttle and full turn, while on dead batteries, be aware!

Honestly not a good impression. Ive had two now and the first one rolled backwards on its own even after being trimmed. Then it started making my emax servo jitter really bad even at straight. And now the second esc ive had for maybe a month and now the servo is jittering again. Not sure what the problem is but horizon support is always helpful i will absolutely give them that.

I have bought this esc/receiver twice, as an upgrade for my v1 scx24s, it make a word of difference, i would highly recommend for most brushed users.

alright esc for stock axial just MAKE SURE YOU PLUG THE MOTOR AND BATTERY INTO THE RIGHT PLUGS, fried two motors and esc's that way XD

I have 2 SCX24's with these receivers my grandsons have thoroughly product tested LOL. My grandsons just arrived for another visit and both SCX24's powered up with completely random behavior. Thanks to another posters review here I checked the transmitter batteries and sure enough, they were really run down. New batteries and everything is running great. So, warning, the stock SCX24 transmitter gives little indication that the batteries are run too far down.

First time turning on and esc does not respond. Servo just twiches. The rest of truck is built well. Just not the electronics.

V2 electronics, no problems with mine. All good. Binded great with a used transmitter. No jitters, trims adjusted. Plugged led to "head" but with black wire to the top most position and used CH3 for off-on-strobe.