This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
Hobbywing XRotor F4 Flight Controller features a high power F4 Processor which is compatible with all common ESC protocols, as well as incredibly fast loop times! Compatible with DShot 1200 down to 150, Oneshot 125, Oneshot 42, & Multishot, XRotor F4 will not leave you in the dust by not offering the best features in the industry. Onboard OSD allows users to configure Betaflight OSD however they see fit, and provide a lot or a little of information over their FPV feed for real time data display. Additional adjustments can be made from the OSD once the aircraft is landed. Lastly, plug and play technology allows the XRotor F4 to be compatible with the Hobbywing 4in1 ESCs providing a clean and easy solution for your next build.
Specifications:
Firmware: OmnibusF4SD
Compatible Modes: PWM, Oneshot125, Oneshot42, Multishot, DShot150, DShot300, DShot600,DShot1200
Compatible Transmitters: PPM, Spektrum, S.Bus, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL
OSD Support: Built-in
Voltage Monitoring: Yes
Current Monitoring: Yes
Buzzer: Supported
LED Contol: Supported
TF-Card: 2-32Gb Suggested - NOT INCLUDED
Size: 35x35mm
Weight: 6g
Specifications:
Firmware: OmnibusF4SD
Compatible Modes: PWM, Oneshot125, Oneshot42, Multishot, DShot150, DShot300, DShot600,DShot1200
Compatible Transmitters: PPM, Spektrum, S.Bus, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL
OSD Support: Built-in
Voltage Monitoring: Yes
Current Monitoring: Yes
Buzzer: Supported
LED Contol: Supported
TF-Card: 2-32Gb Suggested - NOT INCLUDED
Size: 35x35mm
Weight: 6g
This product was added to our catalog on August 25, 2017
Ron Stubblefield
Verified Owner
Monday, Feb 19 2018 (about 6 years ago)
Hobbywing XRotor F4 Flight Controller w/OSD
This is my first F4 flight controller and, so far, it's been nothing but super easy to set up and get flying. Only issue, and it's most likely in Betaflight, is that "RunCam device" is not listed in the ports tab. I'm trying to control my Split2 thru a spare UART. Gonna try flashing BF 3.2.5 and see if that'll resolve it.