This is the Hobbywing XRotor 20A Micro Brushless Drone ESC.
Features:
- Super Small & Light architecture
- F396 48MHz MCU
- Premium MOSFETs (Toshiba MOSFETs for 20A & 35A ESCs, Fairchild MOSFETs for 30A ESCs)
- Ceramic capacitors
- 3-in-1 drive ICs, 3-ounce copper
- Ultra high efficiency & rapid response - 4 layers of PCBs and other quality components guarantees less heat.
- BLHeli Firmware Ready - Users can flash or upgrade the BLHeli firmware via the signal cable (on ESCs), and program 4 ESCs simultaneously after connecting their flight controller to the BLHeliSuite software if the flight controller uses the CleanFlight firmware
- Damped Light Mode & OneShot125 Mode Supported
- Damped light mode improves the motor retardation and allows users to brake the FPV drones more efficiently. Active-freewheeling technology improves driving efficiency, flight time and heat dissipation.
- Support OneShot125 high speed throttle signal and regular throttle signal (within 500Hz) modes.
- ESC + Motor combo available
Specifications:
Application: FPVs with 130-280mm Diagonal
LiPo Power input: 2S-4S
Continuous Current: 20A
Burst Current: 30A
BEC Output: NA
Input wires: 20AWG-100mm* (Red/Black)
Output Wire: Solder tabs (no wires)
Connectors (In/Out): no
Weight / Size: 7g / 24.0x13.9x5.5mm
*Note: All the wire length above is the original length, not the length you see from the outside.
This product was added to our catalog on December 1, 2016
