This is a Hitec High Voltage HSB-9485SH Brushless Steel Gear Digital Servo, designed with Hitec's durable steel gears and impressive brushless motors with the HSB-9485SH bringing immense torque.
Features:
- Programmable 12-Bit PWM Digital Amplifier
- Custom Long Life Brushless Motor
- 1M Cycle Long Life Potentiometer
- Constant Output Torque
- Wide Operating Voltage (5 ~ 9 Volts DC)
- Dual Ball Bearing Supported Output Shaft
- Dust Resistant and Splash Proof Case
- 25-Tooth Output Spline
- Nylon Reinforced Plastic Case
- Ultra Low Power Consumption
Programmable Functions:
- End Point Adjustments
- Direction
- Fail Safe
- Dead Band
- Speed (Slower)
- Soft Start Rate
- Data Save / Load
- Program Reset (From File)
Accessories:
- Steel Gears Set (Link)
- Metal/Karbonite 1st Gear Set (Link)
- Plastic Case Set (Link)
- Applicable Horns (Link 1 • 2 • 3)
Performance Specifications:
Operating Voltage Range: (Volts DC) 6.0V ~ 7.4V
Speed: (Second @ 60°) 0.18 ~ 0.15
Maximum Torque Range oz./in.: 361
Maximum Torque Range kg./cm.: 26.0
Current Draw at Idle: 30 mA
No Load Operating Current Draw: 430 mA
Stall Current Draw: 1,100 mA
Dead Band Width: 1 µs
Physical Specifications:
Dimensions (Inches): 1.57 x 0.78 x 1.45
Dimensions (Metric): 40.0 x 20.0 x 37.0
Weight (Ounces): 2.19
Weight (Gram): 62.0
Circuit Type: EBL Digital
Motor Type: Brushless
Gear Material: Steel
Bearing Type: Dual Ball Bearing
Output Shaft (type / Ømm): H25T
Case Material: Plastic
Dust/Water Resistance Splash Proof: Yes
Connector Gauge (AWG)(Strand Count): 20/80
Limited Warranty:
Hitec Servo Warranty: Each Hitec servo is backed by a limited two-year warranty from the date of purchase. Hitec RCD USA, INC. shall REPAIR OR REPLACE, at Hitec RCD, INC., defective equipment covered by this warranty, otherwise the purchaser and/or consumer is responsible for any charges for the repair or replacement of the product.
This product was added to our catalog on November 25, 2019
