The Hitec HSB-9380TH Ultra Torque Brushless Titanium Gear Servo features an ultra-efficient brushless motor, titanium gears, low current consumption and constant output power. This makes the HSB-93XX series of servos a great choice for discriminating pilots and racers.
NOTE: While compatible with most radio control devices, the regenerative braking feature of the HSB-9XXX series servos may cause a problem if the device cannot accept a backflow of current. The types of devices that cannot accept this backflow are: Voltage Regulators, Power Safe Receivers and certain BEC circuits whether stand alone or integrated within an Electronic Speed Control. Check with the manufacturer or the Hitec website for a list of compatible models. If your device cannot accept a current backflow, then you must install a PAD (Power Absorbing Device - HRC55756) as described in the manual. A PAD is included with every Hitec brushless servo.
Features:
- Programmable 12-Bit PWM Digital Amplifier
- Custom Long Life Brushless Motor
- 1M Cycle Long Life Potentiometer
- Constant Output Torque
- Wide Operating Voltage (5 ~ 9 Volts DC)
- Dual Ball Bearing Supported Output Shaft
- Dust Resistant and Splash Proof Case
- 25-Tooth Output Spline
- Hybrid Nylon Reinforced Plastic and Aluminum Case
- Low Power Consumption
Programmable Functions:
- End Point Adjustments
- Direction
- Fail Safe
- Dead Band
- Speed (Slower)
- Soft Start Rate
- Data Save / Load
- Program Reset (From File)
Specifications:
- Performance:
- Operating Voltage Range (Volts DC): 6.0V ~ 7.4V
- Speed (Second @ 60°): 0.17 ~ 0.14
- Maximum Torque Range oz. / in.: 472
- Maximum Torque Range kg. / cm.: 34
- Current Draw at Idle: 27 mA
- No Load Operating Current Draw: 250 mA
- Stall Current Draw: 2,100 mA
- Dead Band Width: 1 µs
- Physical Specifications:
- Dimensions (Inches): 1.57 x 0.79 x 1.50
- Dimensions (Metric): 40.0 x 20.0 x 38.0
- Weight (Ounces): 2.4
- Weight (Gram): 68.0
- Circuit Type: EBL Digital
- Motor Type: Brushless
- Gear Material: Titanium
- Bearing Type: Dual Ball Bearing
- Output Shaft (type / Ømm): H25T
- Case Material: Plastic / Aluminum
- Dust / Water Resistance: Splash Proof
- Connector Gauge (AWG) / Strand Count: 20 / 80
- Applications:
- Parkflyer: N / A
- Sport Plane: > 40%
- Sailplane: 2 meters and up
- 3D Performance: > 40%
- Scale: > 40%
- Electric Helicopter: N / A
- Gas Helicopter: N / A
- On Road: N / A
- Monster Truck: 1/8th
- Buggies: 1/8th
- Truggies: 1/8th
- Short Course / Truck: 1/8th
- Crawlers: N / A
- Sail Boat: = >1M & Scale
- Power Boat: 1/10th
Limited Warranty:
Hitec Servo Warranty: Each Hitec servo is backed by a limited two-year warranty from the date of purchase. Hitec RCD USA, INC. shall REPAIR OR REPLACE, at Hitec RCD, INC., defective equipment covered by this warranty, otherwise the purchaser and/or consumer is responsible for any charges for the repair or replacement of the product.
This product was added to our catalog on October 5, 2018
