Furitek Raptor SCX24 Aluminum Frame Kit (Red)

red furitek raptor frame kit, the holes for the skid plate/bottom of the transmission either a stock Axial plastic one or say an aftermarket metal one... are too close together so the frame kit cannot be actually attached to the transmission at the bottom. It has been my experience that no after market frame kit for the SCX-24 part has actually been machined properly, though this is the only one I've purchased through Amain. I have a black one on the way, for a different car because I thought this was going to go together much better than the cheaper amazon garbage that has different names but is the same setup... but now I will probably try to return the black one as soon as I get it if the holes aren't set up right.

Holes are not threaded, motor mount plate will not fit unless the stock plastic one is used - 2 front holes are are positioned upward about 1-1.5mm, plastic one can be manipulated. :(