DW Hobby E10 Cessna Electric Foam Airplane Combo Kit (960mm) w/Motor, ESC, & Servos

This plane foe me has been a great flyer. Its smooth, predictable and well mannered. For anyone trying to transition from using stabilized, pilot assist modes to fully manual flight, this is a great next step. The build is pretty straight forward and not difficult if you have a bit of experience. The only negatives for me were some screws not in the kit and you should double check that the pre-installed carbon stiffeners are glued in properly. Nonetheless a great flyer.

Well honestly I can say I'm 67 built a lot of planes,this isn't a easy build,the foam is like a pool noodle no strength hinges they are not,elevator is a joke every thing not flat,won't fly have to replace rudder and elevator with 1/4" poster foam board would not waste your money. china ????????

I did not buy this plane from FT but from ebay. It required a lot more building than I thought. It was basically a kit with all electronics. When built it seemed a lot less strong than foam board planes. Motor was under powered and crashed first flight breaking the prop shaft. Never had a motor break like that. Replaced the motor with 1400kv and got it flying but it never flew well. Made sure cg was on and plane was trimmed. I seem to always fly in windy conditions so this may have been a factor. I bought this because it was cheap but the saying is still valid: you get what you pay for. Skip this plane and buy a nice FT speed build kit instead.