DE Racing BumpSkid (Kyosho MP9 TKI3)

Works perfectly on the Kyosho MP9 Tki4! easy install, perfect fitment, will buy again once this one wears down.

Great product, helps save the front end of the car a lot from big jumps and slaps from taking of steep jumps or over jumping big jumps, I do not recommend the rear gaurd from DE but the front one is much better then the kyosho stock one which protects nothing but the front hinge pin mount

I've used this on 3 versions of Kyosho Infernos: the MP9 TKI4, MP10 TKI2, and MP10 TKI3. Fits each one perfectly and definitely protects the front end from landing the jumps.

One area of improvement would be to improve the plastic. I end up needing to replace these after removing the front drive assembly from the chassis several times for routine maintenance, differential swaps, etc. When you first install this, the pan head screws stretch and thin the plastic between the pan of the screw and contour of the chassis. During initial installation, this is a good thing and ensures a perfect fit. However, the more times you remove and reassemble, the plastic around the screw holes continues to stretch and thin to the point when it thins so much, or completely breaks through, it no longer stays put in the chassis and has to be replaced. This happens long before the wear surface is actually fully worn out. If there is a way to strengthen the material around the screw mounts, it would make these last much, much longer. The same thing is true for the rear protector.

Also fits mp10e tki2 and mp10te or any Kyosho vehicle with front bumper IF409