Common Sense RC Lectron Pro 1S LiPo Battery 35C (3.7v/600mAh) w/UMX Connector

LiPo Battery Overview:

The Common Sense RC 1-cell 3.7V 600mAh LiPo battery pack is specially designed for the E-Flite Blade Glimpse, providing an impressive 20% increase in flight time compared to the stock 500mAh battery. With a continuous discharge rate of 35C, it delivers enhanced punch and higher overall performance. This battery features the correct 1S UMX connector, allowing it to seamlessly integrate with the Inductrix FPV+, Glimpse, and the Blade mCPX.

Features:

• Extended Flight Time: Provides 20% more flight time compared to the stock 500mAh battery.
• High Discharge Rate: 35C continuous discharge rate for increased punch and performance.
• Direct Compatibility: Equipped with the correct 1S UMX connector for seamless integration with Inductrix FPV+, Glimpse, and Blade mCPX.

IMPORTANT LITHIUM POLYMER SAFETY INFORMATION

• DO NOT leave a battery in your model when charging
• DO NOT leave lithium batteries unattended when charging
• ALWAYS balance charge lithium battery
• ALWAYS use a LiPo Safe charging bag/box
• YOU MUST use a Li-Poly specific charger to charge lithium batteries (NiMH or NiCD only chargers WILL NOT WORK!)
• YOU MUST not over discharge lithium battery packs
• READ & UNDERSTAND the instructions carefully before operating this battery

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in overheated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for the first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at temperatures above 35°C or in a closed car. The high-temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging, or racing, do not charge it until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.