This is an optional set of two Team Losi Racing 22X-4 Aluminum CVA Sleeves, meant for use with the 22X-4 1/10 Scale Buggy kit. These sleeves are machined from quality aluminum to be lightweight and strong.
This product was added to our catalog on September 14, 2020
I picked up 2 pairs of these when I grabbed my new 22x4 kit a couple weeks ago. One set installed on the diff end of each center driveshaft and the second gets installed on the outer end of the front CVD's. Not sure if there is any difference in performance or reliability over the stock plastic versions as I didnt weigh them because they are both super small and light, but these aluminum ones sure look nice and match all the other stock and upgraded aluminum parts on the car. NOTE: If you are going to use the double jointed front driveshafts, then you dont use either the stock plastic or these aluminum sleeves with them. I found that out when I built my other 22x4 last year when I ordered both...
Sleeve. Constructed from lightweight aluminum this reducer sleeve adapts 8mm bore pinions to fit a 5mm motor shaft. Package includes one reducer sleeve. Specifications: Total Length: 14.5mm Inner Diameter: 5.0mm Outer Diameter: ...
Team Associated RC8B4 and RC8B4e Factory Team Aluminum ...
CVA Axle Sleeve Set. Constructed from lightweight blue anodized aluminum, these optional CVA axle sleeves are intended for the Team Associated RC8B4 and RC8T4 nitro and electric platforms as an upgrade to ...
Losi Racing 5x8x2.5mm Bearings, and are intended for use with the Team Losi Racing 22 line of 1/10 scale vehicles, as well as the XXX line of 1/10 scale vehicles. These bearings ...